Muriatic acid is an important chemical for your swimming pool to stay comfortable to swim in. You don’t only need a pool cleaner to maintain a nice swim. Spread it evenly around the whole pool, making sure you reach all parts.Īfter about four hours, check the pH balance again to see if it is now balanced. Your pool’s filter must be turned on as you add the mixture to the pool. Be careful when pouring the muriatic acid at Lowes. With the bucket of clean water, add in the acid, about 1/10 of the amount of water you set aside. Using your pool testing kit, check the balance to see if the pH balance is equal or needs muriatic acid. Follow these steps to know how to add muriatic acid to your pool. You will want to make sure that the pH levels remain as close as 7.5 pH, which is the base pH level. If you suffer from irritated eyes, it might not be hydrochloric material, but the pH balance! TOO much pH will end up with scaling, cloudy water, chlorine inefficiency, as well as eye and skin irritation. Too low pH will cause chlorine loss, eye and skin irritation, metal corrosion, or staining. There are a number of factors that may affect your pool’s pH balance, such as swimmer waste or other disinfectants and weather conditions around your area. The low pH will react with the metal parts in the equipment and damage them.When adding muriatic acid to your pool, you will need the following: Never put trichlor tablets into the pool skimmer. Use trichlor in a floating feeder or a tablet chlorinator attached to the pool plumbing. Most trichlor also contains cyanuric acid, a stabilizing agent that acts as a blocker of ultraviolet rays that break down chlorine. Instead, you may occasionally need to increase the pH by adding soda ash or baking soda to the water. Because it has a very low pH (2.8 to 3.0), it's unlikely you will need any muriatic acid at all. Trichlor tablets are also effective in reducing or eliminating the need for muriatic acid. Use the tablets in an erosion type feeder, either a floating feeder in the pool or a tablet chlorinator attached to the pool plumbing. The recommended way to add the granular form is to mix it in a five-gallon bucket to dissolve it and walk it around the pool, pouring it as you go.

Ideal pH for a pool is between 7.2 and 7.6, so dichlor will not raise pH. Sodium dichlor is a granular or tablet form of chlorine sanitizer with a pH range of 6.8 to 7.0, nearly neutral.

How to add muriatic acid to pool